使用 ethtool 更改网络接口速度不起作用

我使用的是具有 Gbps 以太网卡的 lenevo M5 服务器，但奇怪的是，当我读取 cat /sys/class/net/eth3/speed 时，它显示 100，类似地使用 ethtool 时它仅显示 100Mbps。dmesg 和 ethtool 的输出如下。知道为什么

root@server1:~# dmesg |grep eth1
[ 3.027487] tg3 0000:16:00.1 eth1: Tigon3 [partno(BCM95769) rev 5719001] (PCI Express) MAC address 08:94:ef:5d:81:a2
[ 3.027497] tg3 0000:16:00.1 eth1: attached PHY is 5719C (10/100/1000Base-T Ethernet) (WireSpeed[1], EEE[1])
[ 3.027503] tg3 0000:16:00.1 eth1: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[1] TSOcap[1]
[ 3.027508] tg3 0000:16:00.1 eth1: dma_rwctrl[00000001] dma_mask[64-bit]
[ 28.133071] bond0: Adding slave eth1
[ 28.249876] bond0: Enslaving eth1 as a backup interface with an up link
[ 53.149602] tg3 0000:16:00.1 eth1: Link is up at 100 Mbps, full duplex
[ 53.149620] tg3 0000:16:00.1 eth1: Flow control is off for TX and off for RX
[ 53.149624] tg3 0000:16:00.1 eth1: EEE is disabled

# ethtool eth3

Settings for eth3: 
Supported ports: [ TP ] 
Supported link modes: 10baseT/Half 10baseT/Full 
100baseT/Half 100baseT/Full 
1000baseT/Half 1000baseT/Full 
Supported pause frame use: No 
Supports auto-negotiation: Yes 
Advertised link modes: 100baseT/Full 
Advertised pause frame use: Symmetric 
Advertised auto-negotiation: Yes 
Link partner advertised link modes: 100baseT/Half 100baseT/Full 
1000baseT/Full 
Link partner advertised pause frame use: No 
Link partner advertised auto-negotiation: Yes 
Speed: 100Mb/s 
Duplex: Full 
Port: Twisted Pair 
PHYAD: 2 
Transceiver: internal 
Auto-negotiation: on 
MDI-X: off 
Supports Wake-on: g 
Wake-on: g 
Current message level: 0x000000ff (255) 
drv probe link timer ifdown ifup rx_err tx_err 
Link detected: yes 

当我尝试使用ethtool -s eth3 speed 1000 duplex full“速度”部分更改速度时为“未知”，类似地读取（cat）文件 /sys/class/net/eth3/speed 给出无效参数。