我有一台带有无线和有线网络端口的 Cent0S 7 miniPC。无线端口 (wlp3s0) 作为 DHCP 客户端连接,地址为 192.168.10.X,并具有 DNS 解析。
我正在尝试将有线端口(enp2s0)设置为具有 192.168.100.X 寻址的私有子网的 DHCP 服务器。miniPC 将连接到网络交换机,该交换机将连接其他客户端设备进行测试。
我按照从 RedHat 到 T 恤的指示。
我/etc/systemd/system/dhcpd.service
的如下:
[Unit]
Description=DHCPv4 Server Daemon
Documentation=man:dhcpd(8) man:dhcpd.conf(5)
Wants=network-online.target
After=network-online.target
After=time-sync.target
[Service]
Type=notify
ExecStart=/usr/sbin/dhcpd -f -cf /etc/dhcp/dhcpd.conf -user dhcpd -group dhcpd --no-pid enp2s0
[Install]
WantedBy=multi-user.target
我/etc/dhcp/dhcpd.conf
的如下:
default-lease-time 600;
max-lease-time 7200;
authoritative;
subnet 192.168.100.0 netmask 255.255.255.0 {
option routers 192.168.100.1;
option subnet-mask 255.255.255.0;
option broadcast-address 192.168.100.255;
range 192.168.100.10 192.168.100.100;
}
当我去配置和启动服务时:
sudo systemctl --system daemon-reload
sudo systemctl restart dhcpd.service
我得到这个/var/log/messages
:
localhost systemd: Starting DHCPv4 Server Daemon...
localhost dhcpd: Internet Systems Consortium DHCP Server 4.2.5
localhost dhcpd: Copyright 2004-2013 Internet Systems Consortium.
localhost dhcpd: All rights reserved.
localhost dhcpd: For info, please visit https://www.isc.org/software/dhcp/
localhost dhcpd: Not searching LDAP since ldap-server, ldap-port and ldap-base-dn were not specified in the config file
localhost dhcpd: Wrote 0 leases to leases file.
localhost dhcpd:
localhost dhcpd: No subnet declaration for enp2s0 (no IPv4 addresses).
localhost dhcpd: ** Ignoring requests on enp2s0. If this is not what
localhost dhcpd: you want, please write a subnet declaration
localhost dhcpd: in your dhcpd.conf file for the network segment
localhost dhcpd: to which interface enp2s0 is attached. **
localhost dhcpd:
localhost dhcpd:
localhost dhcpd: Not configured to listen on any interfaces!
localhost dhcpd:
localhost dhcpd: This version of ISC DHCP is based on the release available
localhost dhcpd: on ftp.isc.org. Features have been added and other changes
localhost dhcpd: have been made to the base software release in order to make
localhost dhcpd: it work better with this distribution.
localhost dhcpd:
localhost dhcpd: Please report for this software via the CentOS Bugs Database:
localhost dhcpd: http://bugs.centos.org/
localhost dhcpd:
localhost dhcpd: exiting.
localhost systemd: dhcpd.service: main process exited, code=exited, status=1/FAILURE
localhost systemd: Failed to start DHCPv4 Server Daemon.
localhost systemd: Unit dhcpd.service entered failed state.
localhost systemd: dhcpd.service failed.
知道这里出了什么问题吗?
谢谢。
您的第二个接口 (enp2s0) 没有 IP 地址。使用已定义网络中的地址设置他 -
ip addr add 192.168.100.1/24 dev enp2s0
然后再次运行 dhcp 服务。该接口的 IP 地址必须是静态的。在 /etc/sysconfig/network-scripts/ifcfg-enp2s0 中使用静态 IP 地址 192.168.100.1 配置 enp2s0 接口。
https://access.redhat.com/documentation/en-US/Red_Hat_Enterprise_Linux/7/html/Networking_Guide/sec-Using_the_Command_Line_Interface.html